All information on tradrack is stored here for further details: https://github.com/Annex-Engineering/TradRack
In endless spool mode, the multi-tool setup is disabled, so we don't have to worry about T0, T1, etc.
On runout, it should pause, swap material, wipe, and resume printing automagically.
- Check for filament already loaded to the toolhead
- If there is, Try to use the TR-initiate macro to call TR_LOCATE_SELECTOR.
- It should remember the last lane and you should be good to go with the previously loaded materials.
- If not, you can use the TR_HOME command to get the selector to home and then start loading materials.
- Loading Material:
- Use the TR preload lane command to load the corresponding lane. Lane numbering starts with 0 from where its loaded.
- Once all your lanes are preloaded, you can use the load toolhead command from the lane that you want to load from.
- Once loaded, you should be good to go!
¶ Other Tricks and Tips:
Manually swapping materials:
Simply Pause the print, and then use the load toolhead from lane X macro to swap materials, then once loaded, resume the print.